Fabulous Frames Card No. 1

 

www.donnamaree.stampinup.net

PRODUCTS

A4 Cherry Cobbler Cardstock Regals Collection

(AC 121681, Page 123)

12" x 12" Distressed Gold Specialty Paper

(AC 159237, Page 139)

A4 Garden Green Cardstock Regals Collection

(AC 108605, Page 123)

A4 Very Vanilla Cardstock Basics Collection

(AC 106550, Page 123)

Christmas Lights Bundle

(Mini Catalogue July - December 2022 159961, Page 73)

Brushed Metallic Dots

(AC 156506, Page 143)

Twinkling Lights Dies

Stampin' Dimensionals

(AC 104430, Page 127)

Mini Glue Dots

(AC 103683, Page 127)

Fabulous Frames Dies

(AC 159163, Page 171)

Gold & Vanilla Satin Edged Ribbon

(Mini Catalogue July - December 159555, Page 82)

Stampin' Emboss Powder Gold

(AC 155555, Page 128)

Versamark Ink Pad

(AC 102283, Page 129)

Peaceful Deer Stamp Set

(AC 156891, Page 42)

Cherry Cobbler A4 Card Stock [121681] $16.25	Distressed Gold 12" X 12" (30.5 X 30.5 Cm) Specialty Paper [159237] $8.75	Garden Green A4 Card Stock [108605] $16.25	Very Vanilla A4 Card Stock [106550] $18.00
Christmas Lights Bundle (English) [159961] $81.00	Brushed Metallic Adhesive Backed Dots [156506] $15.75	Stampin' Dimensionals [104430] $7.50	Mini Glue Dots [103683] $9.25
Fabulous Frames Dies [159163] $54.00	Gold & Vanilla 3/8" (1 Cm) Satin Edged Ribbon [159555] $14.00	Metallics Embossing Powders [155555] $32.00	Versamark Pad [102283] $16.75
Peaceful Deer Photopolymer Stamp Set (English) [156891] $39.00

Add All to Cart

METHOD & MEASUREMENTS

   1.   Using Cherry Cobbler Cardstock, cut card base at 10.5cm x 29.7cm and score at 14.85cm

   2.   Using Very Vanilla Cardstock, cut one piece at 14.4cm x 10cm

   3.   Using Fabulous Frames dies, cut four large picture frames and adhere with liquid glue stacked on top of each other

   4.   Using Distressed Gold Designer Series Paper, cut one large frame and adhere to the top of stacked Cherry Cobbler frames, adhere to center front of card

   5.   Using Distressed Gold Designer Series Paper cut four corner pieces from Fabulous Frames Dies 

   6.   Using edges of dimensionals pack, cut 8 very fine slivers at 1.8cm long. Adhere to outside edges of corner pieces of gold Designer Series Paper

   7.   Using Cherry Cobbler Cardstock, cut four Christmas trees from the Christmas Lights Bundle

   8.   Adhere stacked on top of each other using liquid adhesive

   9.   Using Garden Green Cardstock, stamp Christmas tree in Versamark and cover with Gold emboss powder and heat set

 10.   Die cut using Twinkle lights dies and adhere to stacked Cherry Cobbler stacked trees

 11.   Using liquid glue, adhere to center front of card base

 12.   Cut any decorative leaves from Vellum and adhere to bottom front left of frame on front of card base

 13.   Cut approximately 10cm of ribbon and tie a bow. Adhee to the front using glue dots

 14.   Tuck the tale of ribbon on both sides slightly under bottom and side edge of frame allowing a slight bump to be visible and adhere tale in place with glue dots. Trim tails to desired length

 15.   Cut one piece of Very Vanilla Cardstock at 11cm x 1.9cm and punch ends with chose punch

 16.   Run banner edges along Versamark pad and cover with gold emboss powder. Heat set.

 17.   Stamp chosen sentiment onto banner in Versamark ink and cover with gold emboss powder and heat set

 18.   Adhere banner to front of card using dimensionals

 19.   Place metallic dots where chosen

 20.   Using Versamark ink, stamp chosen sentiment in centre of Very Vanilla banner

 21.   Cover with gold embossing powder and heat set

 22.   Punch corners as chosen

 23.   Run edges along Versamark ink pad and cover with gold embossing powder, heat set

 24.   Adhere with liquid glue to inside of card base

 25.   Using flue dot adhere die cut leaves of choice onto lower bottom edge of card