(AC 159228, Page 123)
Smoky Slate A4 Cardstock
(AC 131291, Page 122)
Flowing Flowers Stamp Set
(Jan-June Mini Catalogue 157880, Page 36)
Hand Stamped Designer Series Paper using
Rich Razzleberry Ink Pad (AC 147091, Page 122)
Bermuda Bay Ink Pad (AC 147096, Page 122)
Smoky Slate Ink Pad (AC 147113, Page 122)
Crushed Curry Ink Pad Regals Collection (AC 147087, Page 122)
Gray Granite Shimmer Ribbon
(AC 152463, Page 140)
Metallic Mesh Ribbon
(AC 153550, Page 140)
Label Me Lovely Punch (Trimmed to shape required)
(AC 151296, Page 150)
Multipurpose Liquid Glue
(AC 110755, Page 167)
Stampin' Seal
(AC 152813, Page 167)
Stampin' Dimensionals
(AC 104430, Page 167)
Versamark Ink Pad
(AC 102283, Page 129)
Stampin' Emboss Powder
(AC 155554, Page 128)
METHOD AND MEASUREMENTS
1. Using Whisper White Cardstock cut card base at 10.5cm x 29.7cm, fold in half and crease with bone folder
2. Using Smoky Slate Cardstock, cut first layer at 14.4cm x 10cm
3. Cut Silver Mesh at 13.9cm and then in half lengthways
4. Cut one piece of Stamped Designer Series Paper at 6cm x 13.8cm
5. Using Smoky Slate Cardstock, punch out one label
6. Wipe over punched label with Emboss Buddy to remove hand oils and anything that could keep the Stampin' Emboss powder from adhering to the label
7. Choose sentiment, stamp in Versamark Ink onto label, then cover in White Emboss Powder, heat set and allow to cool before touching
8. Depending on size of bow wanted, cut length of ribbon and tie into bow
9. Using Stampin' Seal+ adhere pieces of Silver Mesh to either side back of Designer Series Paper
10. Adhere Smoky Slate first layer onto front of Basic White card base
11. Place dimensionals onto back of Designer Series Paper and adhere down onto the Smoky Slate front layer
12. Using chosen colour, stamp Flowing Flowers image to the inside right hand lower corner of card base
No comments:
Post a Comment