Playful Pets Designer Series Paper

 

 

https://donnamaree.stampinup.net/

PRODUCTS

1 x A4 Whisper White Card Stock 

(Basics Collection 106549, AC page 143)

1 x A4 Basic Black Card Stock 

(Basics Collection 121688, AC page 143)

1 x A4 Soft Suede Card Stock 

 (Neutrals Collection 119982, AC page 142)

1 x A4 Flirty Flamingo Card Stock 

( Brights Collection 141421, AC page 142

Playful Pets Designer Series Paper 

( AC 152489, page 149)

Vellum Square Doilies 

(AC 152484, page 153)

Tailored Tag Punch 

(AC 145667, page 166)

Tasteful Textile 3D Embossing Folder 

 (AC 152718, page 185)

Stitched Rectangle Dies 

(AC 151820, page 183)

Wink of Stella Glitter Brush 

(AC 141897, page 147) 

MEASUREMENTS and METHOD

1.    Cut one piece of A4 Whisper White card stock in half length ways. Fold in half length ways.

2.    Cut one piece of A4 Basic Black card stock at 14.4cm x 10cm. 

3.    Cut one piece of A4 Flirty Flamingo card stock at 14.2cm x 9.8cm, run through Cut & Emboss machine with Tasteful Textile 3D Embossing Folder and adhere to Basic Black layer using whatever adhesive you choose. My preference is liquid tombow glue as it gives me a little more wriggle room to make sure layer is centered.

4.    Cut one piece of Soft Suede card stock at 13.8cm x 4cm and adhere to left hand side of the Flirty Flamingo layer using Stampin' Dimensionals.

5.    Fussy cut one dog and one cat from Playful Pets Designer Series Paper. Adhere cut outs to Basic Black card stock and fussy cut around leaving a very slim border of black. Do the same with one of the fish.

6.    Place a mini black dimensional under both paws of the dog cut out.

7.    Using a piece of thread, stick one end between two of the cut out fish and hang from the upraised paw of the dog. Fish will be free hanging.

8.    Adhere the dog to the bottom left of the Soft Suede layer. This should allow the dog to partially be over the Flirty Flamingo layer as well.

9.    Adhere the cat to the far bottom right hand side of the Flirty Flamingo layer. Use Wink of Stella on the cats collar.

10.    Trim the vellum doily down so only the center diamond remains and adhere to the center of the top of the card in a diamond position.

11.    Stamp chosen sentiment in Black Momento ink in center of Tailored Tag Punch piece, using a dauber and Flirty Flamingo Ink sponge the edges of the punch piece and once ink has dried well, Wink of Stella the edges.

12.    Place dimensionals under the right hand side of the Tailored Tag Punch piece and stick down in the center of the Vellum diamond shape.

13.    Place black dimensionals on the back of the Basic Black layer and adhere to the front of the card.

14.     Cut a piece of the Designer Series Paper with wording on at 14.4cm x 10cm and adhere to the inside of the card.

15.    Die cut a piece of Whisper White card stock using the Stitched So Sweetly dies in what ever size you choose and adhere to the inside of the card, centered.

16.    Punch a piece of Flirty Flamingo card stock with the Tailored Tag Punch. Sponge edge with Flirty Flamingo Ink and stamp chosen sentiment and adhere to the center of the Stitched So Sweetly die cut.